![]() Alan finally found a great place to get them cast using the quality of steel required. ![]() Which gives a good solid rebound, needed to be made. Good strong cast Steel anvils Manufactured to a surface hardness rating HRC 58. Good quality is hard to come by, so this was the only real option. In the end, he had to get them made to order. Getting our Anvils madeĪlan did his very best to search high and low, across land and sea to find the very best anvils he could. Doing so will cause you countless hours of frustration and reworking of mistakes. But you should never look to sacrifice quality on your anvil and your hammer. You can make your own tongs for example or a forge can be a satellite dish and a blow dryer. When it comes to blacksmithing, in some areas, you can skimp on the quality of your equipment. ![]() Finding such quality amongst the myriad of cheap stuff out there was difficult in today’s market place. Alan has always preferred the anvils that have been cast, then surface ground & hardened and then tested for hardness. Alan needed to decide what anvils he was going to sell. Anvils By Sekao Engineering Finding such quality When decided that they would start to sell Anvils. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |